These are our timeless sloped blade front sights. Our GUIDE SERIES PATRIDGE BLADE FRONT SIGHTS 1/2" wide bases are used in "direct to barrel dovetail" mounting without a ramp.Ī 3/8" wide base sight can look good in a slim octagon barrel or thinner round barrel. Generally, 1/4" and 3/8" are used in conjunction with RAMPS and are sized to match the TOP of the ramp width. Width is measured RIGHT to LEFT as viewed looking down the barrel We make this sight in 3 base widths and several heights This gives you more consistency in aiming. Since you are always shooting to the "tip" or "top" of the sight, the bullet point of impact is not covered up by a bead or fiber optic. Patridge blade sights can be trimmed to height as needed. They have crisp serrated faces, square flat tops, and are the perfect PATRIDGE BLADE sight.īlades are. These sights are machined from solid STEEL or BRASS Barstock. WE HAVE TWO TYPES OF BLADE SIGHTS AVAILABLE Fitting instructions included with our rear sights or found at the bottom of this page.
Consequently, we make our front sight dovetails slightly oversize. A well made front sight is critical to accuracy.īlades (Most accurate/durable/easily trimmed to height if needed, strongest, can be painted if desired)īeads: (Most traditional, easy to see, for some it feels more natural)įiber Optics: (Easiest to see, fast target acquisition, good in very low light)įRONT SIGHT HEIGHTS ARE MEASURED FROM THE BOTTOM OF THE DOVETAIL TO THE TOP OF THE SIGHTįITTING: Dovetails vary in size between manufactures, models, even individual guns of the same make and model. Some information about front sights may be helpful as an introduction to help make the best selection for your use.
0 kommentar(er)
